Wilson 700-2700mhz 3-Way 50ohm Splitter Splitters are used in wireless amplifier (repeater) setups to split the amplified signal with minimum signal loss, so that you can utilize three interior antennas for greater coverage. Equal amounts of signal are sent to three antennas for similarly sized areas (for example, one on each floor of a 3-story building to rebroadcast the boosted signal to all floors). You will need a "jumper" cable with an N-Male connector to connect your amplifier to the splitter. The setup will look like this: outside antenna -> cable -> amplifier -> jumper cable -> splitter -> 3 x cable -> 3 x interior antenna Features: 698~2700 MHz Band Cellular Mobile Communication Low Insertion Loss, Low VSWR High Isolation, Low Ripple Microstrip Structure Inline Design This splitter is only for use with 50ohm wireless repeater systems. It CANNOT be used with 75ohm systems, and it CANNOT be used with direct connect amplifiers (direct connect amplifiers are built to connect to the antenna port of one device; you cannot use a splitter to connect it to two devices). 859980 859980

Wilson Electronics

Cable & Accessory

811815020066

$ $99.99 811815020066 https://5gstore.com/product/2813_wilson-859980-three-way-splitter-50ohm.html

Splitters are used in wireless amplifier (repeater) setups to split the amplified signal with minimum signal loss, so that you can utilize three interior antennas for greater coverage. Equal amounts of signal are sent to three antennas for similarly sized areas (for example, one on each floor of a 3-story building to rebroadcast the boosted signal to all floors).

You will need a "jumper" cable with an N-Male connector to connect your amplifier to the splitter.

The setup will look like this:

outside antenna -> cable -> amplifier -> jumper cable -> splitter -> 3 x cable -> 3 x interior antenna

Features:

698~2700 MHz Band
Cellular Mobile Communication
Low Insertion Loss, Low VSWR
High Isolation, Low Ripple
Microstrip Structure
Inline Design

This splitter is only for use with 50ohm wireless repeater systems. It CANNOT be used with 75ohm systems, and it CANNOT be used with direct connect amplifiers (direct connect amplifiers are built to connect to the antenna port of one device; you cannot use a splitter to connect it to two devices).

Specs:

Frequency Range: 698-2700Mhz
VSRW: ≥1.4
Insertion Loss, dB: -4.8
Isolation, 2B: ≥20
Maximum Power: 50W
Connectors: N-Female
Impedance: 50ohms
Dimensions: 3.9×2.9×0.78"
Weight: 6.34oz
Operating Temperature: -40-140°F

There are currently no product reviews.

If you purchased this item, Login to write a review.

Q & A

Got questions about this product? Here you can view questions that other customers have asked (and the answers!). If you have a question that hasn't been answered below, you may submit a new question and 5Gstore will answer it!

Click here to submit a new question

Sort By:

Does using the Wilson splitter reduce the effectiveness of the inside signal?

Yes, each time you split a signal you divide the signal in half. So, for a three way splitter if you were getting 120' off a single antenna then split it 3-ways you'd only get roughly 40' off each antenna after the split. This is why you see larger amplifiers kits that can still repeat far despite multiple splits.