If one antenna is inadequate to rebroadcast boosted signal from your aplifier to your entire building, the Wilson 4-Way Splitter will help improve coverage. Connecting this 50-ohm wide-band splitter to your amplifier lets you divide the boosted signal among up to four interior antennas. It automatically sends an equal amount of signal to each antenna with minimal loss. This setup is ideal for multi-story buildings and L-shaped buildings where walls and flooring prevent an amplifier or repeater signal from reaching the spots farthest away.
Wilson’s 50ohm 4-way splitter will work with all 50ohm booster systems and covers every major North American 2G/3G/4G frequency range. It has a wide operating temperature range, low profile and up to 50 watts of operating power, so you can rely on it in most indoor conditions without causing problems for the rest of your setup. A separate N-male jumper cable (not included) is required to connect the splitter to the amplifier, as well as cables to connect to each antenna. The 5GStore customer service team is available by phone and email to answer questions about this and other cell booster splitters.
You will need a "jumper" cable with an N-Male connector to connect your amplifier to the splitter.
The setup will look like this:
outside antenna -> cable -> amplifier -> jumper cable -> splitter -> 4 x cable -> 4 x interior antenna
Features:
- 698~2700 MHz Band
- Cellular Mobile Communication
- Low Insertion Loss, Low VSWR
- High Isolation, Low Ripple
- Microstrip Structure
- Inline Design
This splitter is only for use with 50ohm wireless repeater systems. It CANNOT be used with 75ohm systems, and it CANNOT be used with direct connect amplifiers (direct connect amplifiers are built to connect to the antenna port of one device; you cannot use a splitter to connect it to two devices).
